COPYRIGHT 2017 DongGuan XingPin Aluminum Co., Ltd. ALL RIGHTS RESERVED
Sweep the phone website
ADD： Shek Pai Town, Dongguan City water
shellfish industrial zone
—— NEWS ——
30 years focused on aluminum extrusion technology and aluminum products surface treatment manufacturers
Categories of news
Aluminum products, aluminum products manufacturers processing aluminum processing technology
Aluminum profiles in our life is a common product, it is one of the indispensable raw materials in the modern industrial industry, then master the aluminum processing technology is very important, the following aluminum products aluminum manufacturers You read the general steps of aluminum processing:
Step one, determine the fancy
Will be made of aluminum material into a corresponding one at a time of the embossing machine, by adjusting the knife edge to control the appearance and spacing of aluminum embossing.Note that the aluminum must be pressed out of the heating process required Texture patterns, this is the first step in the manufacture of aluminum profiles.
Step two, connecting aluminum
After the above embossing step is over, the second step in making the aluminum profile is to heat the pressed material and then connect the thermal strips to the embossed slots to allow them to be combined.
First of all we need to know the surface of the aluminum products produced bubbles what is the reason in the aluminum processing, the internal gas or the air involved in the extrusion process, in the subsequent process of aluminum manufacturer process , Especially when squeezed and heat treatment will produce expansion, resulting in bulging aluminum surface processed products, resulting in some processed products defects.
Aluminum surface processed bubbles solution to the problem are the following:
1、try to reduce the aluminum alloy cast rod internal air content.
2、to ensure that the aluminum alloy cast rod surface is clean, no oil..
3、aluminum rod temperature can not be too high.